American Standard flushometer push buttons
We have quite a few of these american standards in some new schools of ours. We have had horrible luck with the push button sticking.
To replace the push button you have to remove the top cap and (electronics wire nipple out of the back, remove the diaphram and then reach down to grab a clip in the middle of the valve and then take out a set screw on the outside of the handle. It takes a lnog time to replace when you are use to the sloans. Any suggestion on how to make these little over priced part to last longer?
(It doesn't matter if its elementary through high schools. They all seem to eventually stick)
Any suggestions would be helpful ( other then throwing them all out. We can't do that yet :D)
Via RSSMix.com Mix ID 8247361 http://www.rssmix.com/
To replace the push button you have to remove the top cap and (electronics wire nipple out of the back, remove the diaphram and then reach down to grab a clip in the middle of the valve and then take out a set screw on the outside of the handle. It takes a lnog time to replace when you are use to the sloans. Any suggestion on how to make these little over priced part to last longer?
(It doesn't matter if its elementary through high schools. They all seem to eventually stick)
Any suggestions would be helpful ( other then throwing them all out. We can't do that yet :D)
Comments
Post a Comment